Propex Heatsource HS2800 Heater V2 Twin Vehicle Kit

Product code: HS2800V2
£609.00
The Propex HS2800 is an automatic thermostatically controlled blown air heating system fuelled by propane or gas. Heatsource is designed for a variety of automotive and marine aplications as a source of heat totally independant of the engine.  
You will earn 609 points with this purchase



Propex Heatsource HS2800 Heater V2 Twin Vehicle Kit

Propex Heatsource HS2800 Heater V2 Twin Vehicle Kit

Propex Heatsource HS2800 Heater Unit + Twin Outlet Vehicle Kit
The Propex HS2800 is an automatic thermostatically controlled blown air heating system fuelled by propane or gas. Heatsource is designed for a variety of automotive and marine aplications as a source of heat totally independant of the engine.
 
Special Features

  • Runs on clean burning propane or butane gas
  • Quiet thermostatic operation
  • Stainless steel burner and heat exchanger with clean combustion gives maintenance free durability
  • Low electrical current consumption
  • Compact and easy to install
  • Fast warm-up time
  • Reduces condensation
  • High quality motor with ball race bearings
  • Advanced micro-processor electronics
  • Self diagnostic fault finding system
  • Fully CE compliant and tested to the latest European standards
A Twin outlet single kit (V2) contains
  • 2 x metre 76mm ducting
  • 1 x 1 metre 26mm combustion inlet pipe
  • 1 x 0.75 metre 26mm Stainless Steel Exhaust pipe
  • 1 x Thermostat
  • 3.5 metres thermostat wiring harness
  • 3.5 metres 12v supply harness
  • 1 x directional hot air outlet
  • 1 x Open/Close vent
  • 1 x Y branch
  • 1 x directional cool air return vent
  • Hose clips, fasteners, screws, inline fuse, instructions, drilling template

Applications

Propex Heatsource blown air systems are used in many applications throughout the world, these include Motorhomes, Caravans, Boats, Cranes, Horseboxes, Mobile Workshops etc. Both 12 and 24 volt versions are available.

Control

The HS2800 is supplied as standard with a solid state electronic thermostat which automatically switches the unit on and off to maintain the desired temperature. When the room temperature drops below the selected level, the Heatsource will automatically ignite and run until the cabin reaches the selected temperature. The thermostat is an easy to fit surface mount design and integrates with the new electronics fitted to the HS2000 and HS2800 heaters. An easy to operate panel mounted digital timer/thermostat specifically designed for Heatsource, is also available. Unlike some heaters, there is minimal electric current consumption during ignition so cycling the Heatsource on and off does not have the effect of additional battery drain.

Economy

The chart below reflects the consumption of gas if the heater was running continuously. In reality, both heaters have similar very high efficiency ratings, so the overall gas consumption will be about the same because the HS2800 will be running for a shorter period of time before the thermostat switches it off
 
HS2800 Economy & Consumption
Average consumption 225 grams/hour
3.9kg propane cylinder 17.5 hours
4.5kg butane 20.0 hours
13kg propane 58.0 hours
15kg butane 67.0 hours
19kg butane 84.5 hours
47kg butane 209.0 hours
904 Camping gaz (1.81kg) 8.0 hours
907 Camping gaz (2.72kg) 12.0 hours

Technical Specifications

HS2800
Heat Input: 3.0kW
Heat Output: 2.8kW
Voltage: 12V
Current Consumption: 1.9A continuous running
Air Throughput: 85 C.F.M.
Fuel: Butane or Propane Gas
Own this product? Let us know what you think.
Brand Propex
Condition New
Product Code HS2800V2