Connection methods

• Keder Beading - The tunnel has Keder beading sewn to its top edge. The beading can be threaded into ‘figure-of-8’ extrusion (not supplied) and the figure-of-8 clipped to the gutter on the side of the vehicle. Kampa figure-of-8 extrusion is available on our website.​​​
• Guyline / Rope - If your camper does not have a gutter it is possible to pull the tunnel to the vehicle by attaching guy lines/ropes (not supplied) to the top corners of the tunnel, throwing these over the vehicle and tying them to the wheels or pegging them down. Take care that the guy lines/ropes do not damage the vehicle. ​
• Velcro Straps - If your vehicle has roof bars installed, the velcro straps, attached to the pole sleeve, can be fixed around them.
• Pole & Clamp (optional parts required) - This requires an optional pole and clamp set available from your dealer. The pole is threaded through the sleeve in the top of the tunnel. This is then dropped into the gutter on the side of the camper and secured using the clamps provided.
• Using your roll out awning (if fitted) - The Keder beading can be slid into the channel found on the front of most roll out awnings. It may be necessary to use a Drive-Away kit to convert the size of the beading. Pre-attached 6mm Kador strip can be used with a 6mm to 4mm Drive-Away Kit to attach to a Fiamma or Omnistor wind-out sun canopy.

Related products

Kampa Dometic Action Fleece Carpet

Kampa Inner Tent For Action Awnings